Subaru SVX 1992 Manual page 930

4-5 [WlA1]
PEDAL SYSTEM AND CONTROL CABLES
W SERVICE PROCEDURE
Supplemental Restraint System
"Airbag"
Airbag system wiring harness is routed near the pedal
system .
a . All Airbag system wiring harness and connectors
are colored yellow . Do not use electrical test equip-
ment on these circuit .
b. Be careful not to damage Airbag system wiring
harness when servicing the pedal system .
A: ON-CAR SERVICE
2. ACCELERATOR PEDAL
Check pedal stroke and free play by operating acceler-
ator pedal by hand .
If it is not within specified value, adjust it by turning nut
connecting accelerator cable to throttle body .
Free play at pedal pad :
1 - 4 mm (0.04 - 0.16 in)
Stroke :
at pedal pad
53 - 57 mm (2.09 - 2.24 in)
1 . BRAKE PEDAL
1) Check position of pedal pad .
If it is not in specified value, adjust it by adjusting brake
booster operating rod length .
2) Check free play by operating pedal by hand .
If it is not in specified value, adjust it by adjusting
position of stop lamp switch .
Be careful not to rotate stop lamp switch .
3) Apply grease to operating rod connecting pin to
prevent it from wearing .
Brake pedal free play :
1-3 mm (0.04-0 .12 in)
[Depress brake pedal pad with a force of
less than 10 N (1 kg, 2 lb)]
C4-092
Fig . 2
Stroke
at cable end
.i
Stroke
at pedal pad
C4-093
Fig . 3
4
1 - 3 mm (0 .04 - 0.12 in)