Subaru SVX 1992 Manual page 627

AWD SYSTEM
[W2Co) 3-4
b. Prepare an oil can and cap since the transmission oil
flows out from the extension at removing propeller
shaft.
c. When removing propeller shaft, pay attention not to
damage the sliding surfaces of rear drive shaft (exten-
sion) spline, oil seal and sleeve yoke .
d. Insert the cap into the extension to prevent trans-
mission oil from flowing out immediately after remov-
ing the propeller shaft.
10) Remove the DOJ of rear drive shaft from the rear
differential .
For removal of DOJ from the rear differential, refer to
"3-4 AWD SYSTEM" [W2A2] .
11) Secure rear drive shaft to rear sub frame using wire .
12) Remove the rear differential ASSY from body .
(1) Remove the four bolts which secure the bracket
to the rear differential member,
rig. 4o
(2) Support the rear differential with transmission
jack.
r, Rear differential
Transmission jack
C3-156
Fig . 47
rig . 40
(4) Remove the self locking nuts which connect the
rear differential to the rear sub frame.
rig . 4y
(5) While slowly lowering transmission jack, move
the rear differential forward and remove bolts from
the rear sub frame.
rig . av
(3) Remove the two bolts which secure the bracket
Do not tilt the rear differential, or rear differential gear
and rear differential to rear differential member .
oil will spill out.
(6) Remove the rear differential ASSY from body.
21