Subaru SVX 1992 Manual page 725

WHEELS AND AXLES [w6Co] 4-2
4) Install DOJ inner race on shaft and fit snap ring with
special pliers.
Confirm that the snap ring is completely fitted in the
shaft groove.
0O
tee
U °
Al 6-199
Fig . 131
5) Install cage, which was previously fitted, to inner
race fixed upon shaft.
Fit the cage with the protruded part aligned with the
track on the inner race and then turn by a half pitch.
1 Inner race
2 Cage
Al 6-022
Fig . 132
6) Fill 80 to 90 g (2 .82 to 3 .17 oz) of specified grease
into the interior of DOJ outer race .
7) Apply a coat of specified grease to the cage pocket
and six balls.
8) Insert six balls into the cage pocket .
9) Align the outer race track and ball positions and
place in the part where shaft, inner race, cage and balls
are previously installed, and then fit outer race.
O 1 Outer race
2 Grease
B4-616
Fig . 133
10) Install circlip in the groove on DOJ outer race .
a. Assure that the balls, cage and inner race are com-
pletely fitted in the outer race of DOJ.
b. Exercise care not to place the matched position of
circlip in the ball groove of outer race.
c. Pull the shaft lightly and assure that the circlip is
completely fitted in the groove.
c
B4-615
Fig . 134
11) Apply an even coat of the specified grease [20 to 30
g (0 .71 to 1 .06 oz)] to the entire inner surface of boot .
Also apply grease to shaft. =
12) Install DOJ boot taking care not to twist it.
a. The inside of the larger end of DOJ boot and the
boot groove shall be cleaned so as to be free from
grease and other substances.
b. When installing DOJ boot, position outer race of
DOJ at center of its travel.
13) Put a band through the clip and wind twice in
alignment with band groove of boot.
Use a new band.
14) Pinch the end of band with pliers . Hold the clip and
tighten securely . -
When tightening boot, exercise care so that the air
within the boot is appropriate.
41