Table of Contents
Advertisement
3- 2 (w5AOI
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
5 . Reduction Drive Gear Assem-
bly
A: DISASSEMBLY
1) Take out the seal rings .
Be careful not to damage the seal rings .
Fig. 223
2) Take out the snap ring (out) .
Be careful not to damage the splines.
3) Using a press, remove the reduction drive gear.
1-1g. Z14
4) Using a press, remove the ball bearing .
1-1y . ZZU
B: INSPECTION
Make sure that each component is free of harmful
gouges, cuts, or dust .
C: ASSEMBLY
1) Press-fit the ball bearing and reduction drive gear to
the shaft.
Reduction drive gear
Ball bearing
Reduction drive shaft
B3-361
Fig. 226
2) Fit the snap ring securely in the snap ring grove on
the shaft.
3) Attach two seal rings .
To make subsequent assembly easier, apply vaseline
to the grooves of the shaft and to the exterior of the
seal ring.
150
Advertisement
Table of Contents
Troubleshooting
