Subaru SVX 1992 Manual page 784

4-3 [w4C1] STEERING SYSTEM
7) Reassembly of valve ASSY
(1) Apply a coat of grease to inner wall of valve
housing, Y-packing and outer perimeter of dust seal .
Grease
Valve housing
X
-
-_ X
04-071
Fig . 125
(2) Using INSTALLER and press, install dust seal .
a. Face dust seal in the direction shown in Figure 126.
b. Apply a coat of grease to contact surface of installer
and dust seal when installing dust seal . Be careful not
to scratch dust seal during installation.
I
INSTALLER
(34099PA080)
Dust seal
04-072
Fig . 126
(3) Using INSTALLER and press, install Y-packing
and back-up washer in valve housing .
a . Face Y-packing in the direction shown in Figure 127
when installing.
b . To avoid scratching Y-packing, apply a coat of
grease to contact surface of installer and Y-packing.
c . To facilitate installation, attach Y-packing and back-
up washer to installer and position in valve housing
before pressing into place.
INSTALLER
(34099PA080)
Y-packing
Back-up washer
04-073
Fig. 127
(4) Attach SPACER to REMOVER, and press ball
bearing into place using a press .
a . To facilitate installation, attach ball bearing to re-
mover and position in valve housing before pressing it
into place .
b . Use the "B" end of remover.
REMOVER
(927540000)
SPACER
` (927560000)
I
J
04-074
Fig. 128
C4-0761
Fig . 129
54
Grease