Subaru SVX 1992 Manual page 532

3- 2 [w9Ao]
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
9 . Reverse Clutch
14)
s i
20
Ii
12
i3
. : I
AD
9
1 Reverse clutch drum
8 Snap ring
2 Lip seal
9 Dish plate
3 Reverse clutch piston
10 Driven plate
4 Lathe cut seal ring
11 Drive plate
5 Spring
12 Retaining plate
6 Spring
13 Snap ring
7 Spring retainer
14
High clutch drum
B3-384
Fig. 249
A: DISASSEMBLY
1) Remove the snap ring, and take out the retaining
plate, drive plates, driven plates, and dish plate .
2) Using the COMPRESSOR (398673600), INSTALLER
(398177700) and PLIER (399893600), remove the snap
ring and take out the spring retainer and springs .
3) Take out the piston by applying compressed air .
Pay attention to the orientation of the dish plate.
3) Checking operation :
Apply compressed air intermittently to the oil hole, and
check the reverse clutch for smooth operation.
4) Measuring clearance (Retaining plate selection) .
Standard value:
0 .5 - 0.8 mm (0.020 - 0.031 in)
Allowable limit : 1 .2 mm (0.047 in)
B : INSPECTION
1) Drive plate facing for wear and damage
2) Snap ring for wear, return spring for breakage or
setting, and spring retainer for deformation
3) Lip seal and lathe cut seal ring for damage
4) Piston check ball for operation
C: ASSEMBLY
1) Using the same special tools as those used in disas-
sembling, assemble piston the return springs, spring
retainer and snap ring .
2) Assemble the dish plate, driven plates, drive plates
and retaining plate in that order and attach the snap
ring .
Before measuring clearance, place the same thickness
of shim on both sides to prevent retaining plate from
tilting .
Available retaining plates
Part No. Thickness mm (in)
31567AA000 4 .6 (0 .181)
31567AA020 4 .8 (0 .189)
31567AA030 5 .0 (0 .197)
31567AA040 5 .2 (0 .205)
31567AA050 5.4 (0 .213)
158