Subaru SVX 1992 Manual page 728

4-2 [W7e01 WHEELS AND AXLES
3) If rim runout exceeds specifications, remove tire
from rim and check runout while attaching dial gauge to
positions shown in the figure below.
X
Approx . 7 a N
Approx . 7
(0 .28) Q
(0 .28)
Unit : mm (in)
v
C4-592
Fig . 143
If measured runout still exceeds specifications, replace
the wheel.
B : PRECAUTIONS
Aluminum wheels are easily scratched . To maintain
their appearance and safety, observe the following :
1 ) Do not damage aluminum wheels during removal,
disassembly, installation, wheel balancing, etc. After
removing aluminum wheels, place them on a rubber
mat, etc.
2) While vehicle is being driven, be careful not to ride
over sharp obstacles or allow aluminum wheels to
contac~L the shoulder of the road .
3) When installing tire chain, be sure to install it prop-
erly not to have a slack; otherwise it may hit wheel while
driving .
4) When washing aluminum wheel, use neutral syn-
thetic detergent and water . Avoid using the cleanser
including abrasive, hard brushes or an automatic car
washer .
8. Wheel Balancing
1) Proper wheel balance may be lost if the tire is
repaired or if it wears . Check the tire for dynamic
balance, and repair as necessary .
2) To check for dynamic balance, use a dynamic bal-
ancer. Drive in the balance weight on both the top and
rear sides of the rim.
3) Some types of balancer can cause damage to the
wheel . Use an appropriate balancer when adjusting the
wheel balance .
4) Use genuine balance weights .
A mm (in)
Weight for aluminum wheel
4.6 - 5.4
(0 .181 -0 .213)
C4-354
Fig. 144
a. All balance weights shown in Table are colored
silver.
b. 55 g (1 .94 oz) weight used with aluminum wheel-is
not available.
c. Balance weights are available for use with any of
16-inch wheels.
44
Weight for aluminum wheel