Subaru SVX 1992 Manual page 785

STEERING SYSTEM [W4C2] 4-3
(5) Apply a coat of grease to GUIDE surface, and
install GUIDE onto end of input shaft. Insert pinion £r
valve ASSY until "A" of oil seal contacts "B" of valve
housing . The GUIDE is used to prevent scratching
Y-packing .
Grease
x x X
x x
x
~ X X
x
,y B GUIDE
(926310000)
C4-077
Fig . 130
(6) Secure input shaft with press and insert valve
ASSY into valve housing.
Do not allow spacer to extend beyond brazed end .
Otherwise, pinion cannot be inserted properly .
Fig. 131
(7) Apply a coat of grease to sealing lips of dust
cover and insert dust cover until it contacts staged
portion of input shaft.
2 . ELECTRONICALLY CONTROLLED TYPE
Before assembly, clean parts and tools in kerosene and
dry with compressed air . (Do not use organic solvent.)
1) Apply grease to oil seal lip . Drive COVER and
SPACER into place as shown in figure below.
Cover
Oil seal
(926270000)
Spacer
(927570000)
04-086
Fig . 132
2) Place INSTALLER D (927520000) on hand press . Set
ball bearing packed with grease into INSTALLER and
put spacer on it .
3) Place INSTALLER E onto pinion £r valve ASSY with
valve sleeve removed. Carefully press INSTALLER into
place.
Set pinion pin into slot on INSTALLER E end surface.
' Installer E
/(927530000)
Set pinion pin Set pinion pin
into slot . into slot .
Spacer
Ball bearing
Installer D
(927520000)
04-087
Fig . 133
55