Subaru SVX 1992 Manual page 512

3- 2 [w4B2] AUTOMATIC TRANSMISSION AND DIFFERENTIAL
a. Pay attention to the orientation of the oil seals.
b. Be careful not to damage the seal lips. If any
damage is found, replace with a new one.
14) Attach the O-ring to the oil seal retainer with vase-
line . Install the seal to the oil pump housing bore .
Fig. 182
Fig. 184
17) Install the rubber seal to the converter case .
Be careful not to lose the rubber seal.
2. TRANSMISSION CASE SECTION
1 ) Press-fit the roller bearing to the transmission case.
15) Install the oil seal retainer taking care not to damage
the oil seal lips . Then secure with three bolts.
Make sure the O-ring is fitted correctly in position .
Tightening torque :
6 - 8 N"m (0 .6 - 0.8 kg-m, 4.3 - 5.8 ft-Ib)
Fig. 183
16) Apply vaseline to the groove on the oil pump cover,
and install two (R) seal rings and two (H) seal rings .
a. Fit the seal ring after compressing, and rub vaseline
into the seal ring to avoid expansion .
b. The "R" seal ring has a large diameter, while "H"
has small diameter.
DRIFT
(398487700)
G~y
,. Roller bearing
T
1I
133-318
Fig. 185
2) Using a plastic hammer, force-fit the oil seal.
B3-319
Fig. 186
3) Install the manual plate and shaft, and secure with a
spring pin .
a. Be careful not to damage the oil seal lip .
b . After installation, make sure of smooth movement .
138