Table of Contents
Advertisement
ENGINE AND TRANSMISSION MOUNTING SYSTEM
[w4,eoj 2-11
B: INSTALLATION
1 . Install transmission to engine .
2 . Install transmission rear crossm
3. Takeoff transmission jack .
4 . Tighten nuts which hold lower side of transmission to engine .
5. Connect ATIr cooler hoses to pipes on transmission side .
6 . Tighten bolt which hold upper side of transmission to engine.
7 . Install ATF level gauge and front differential oil level gauge .
8 . Install torque converter to drive plate .
9 .
stopper a
11 . Install starter ASSY .
12 . Install front axle shaft into transmission.
13 . Install selector cable to selector lever ASSY
14 . Install selector cable bracket onto body .
15 . Install performance rod .
Ii t>. insian propeuer snarr .
17. Install exhaust system .
18 . Install under cover .
19 . Connect harness connector and hoses .
21 . Install air intake system .
22 . Check ATF level, and correct if necessary .
23. Connect battery ground cable .
24. Remove front hood stay, and close front hood .
25. Check selector lever operation .
26. Take off the vehicle from lift arms .
27 . Check the vehicle with road test .
25
Advertisement
Table of Contents
Troubleshooting
