Subaru SVX 1992 Manual page 726

4-2 [W6CO] WHEELS AND AXLES
15) Tighten band by using BAND TIGHTENING TOOL
(925091000).
a. Tighten band until it cannot be moved by hand.
b . Former BAND TIGHTENING TOOL (925090000) is
interchangeable with this 925091000 .
BAND TIGHTENING TOOL
(92509 0000)
C4-197
Fig. 135
16) Tap on the clip with the punch provided at the end
of BAND TIGHTENING TOOL .
Tap to an extent that the boot underneath is not
damaged.
.I:
o
C4-198
Fig . 136
17) Cut off band with an allowance of about 10 mm
(0 .39 in) left from the clip and bend this allowance over
the clip .
Be careful so that the end of the band is in close
contact with clip .
18) Fix up boot on BJ in the same manner .
19) Place protector onto BJ boot band .
Extend and retract DOJ to provide equal grease coat-
ing .
Discard circlip on left DOJ spline, and install new one .
20) Using SIDE OIL SEAL PROTECTOR (28099PA090),
install DOJ into differential .
--
/
J ~ P\`
.
Q'" < < ~IJ ~ , ,a
r
//SIDE OIL SEAL PROTECTOR
(28099 PA090)
C4-152
Fig . 137
21) Insert DOJ splined end into bore of oil side seal,
and remove SIDE OIL SEAL PROTECTOR .
Do not allow DOJ splines to damage side oil seal .
Fig. 138
22) Mesh DOJ with differential splines .
23) Push housing to insert DOJ into differential .
Check to make sure DOJ is inserted properly .
Fig. 139
42