Subaru SVX 1992 Manual page 542

3- 2 [w15C0)
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
I
INSTALLER
(499247400)
Seal, piston
PISTON GUIDE
1499257400)
TABLE (498267400)
B3-410
Fig . 273
I ly . Z/ V
Be careful not to tilt transfer piston seal. 5) Check the clearance :
(4) Place transfer piston seal guide onto rear drive
shaft so that spring can be inserted into hole in
Standard value :
transfer piston seal .
0.2 - 0.6 mm (0 .008 - 0.024 in)
(5) Attach outer snap ring guide to rear drive shaft.
Allowable limit : 1 .6 mm (0 .063 in)
Using an outer snap ring installer, press into place.
INSTALLER
(499247400)
SNAP RING OUTER GUIDE
Snap ring
(499257300)
A ring
(499257400)
,~ PISTON GUIDE
Seal, piston I
B3-411
Fig . 274
If the clearance is not within the specified range, select
a proper pressure plate .
Before measuring clearance, place the same thickness
of shim on both sides to prevent pressure plate from
tilting.
Available pressure plates
Part No .
Thickness mm (in)
31593AA150 3 .3 (0 .130)
31593AA160 3 .7 (0 .146)
31593AAl70 4.1 (0 .161)
31593AA180
4.5 (0 .177)
6) Press-fit the ball bearing .
INSTALLER (899580100)
Ball bearing
B3-412
Fig . 277
7) Coat the seal ring with vaseline, and install it in the
Fig. 275
seal ring groove of the shaft.
Do not expand the seal ring excessively when install-
3) Install the driven plates, drive plates, and pressure
ing .
plate, and secure with a snap ring .
4) Apply compressed air to see if the assembled parts
move smoothly .
168
Do not allow lip of transfer piston seal to fold back .