Subaru SVX 1992 Manual page 874

4-4 [W3CO] BRAKES
2) Installation is in reverse order of removal .
a . Use new retainers and clinch them when installing
brake shoes to levers.
b . Ensure that parking lever moves smoothly .
c. Do not confuse left parking lever with right one.
d . Do not confuse left strut with right one.
e. Ensure that adjuster assembly is securely installed
with screw in the left side.
L T
<=
EF
CVC05
~~a
4) Check back plate bolt tightening torque as follows :
(1) Remove caliper and disc rotor .
(2) Remove tone wheel attaching bolts .
Fig. 86
(3) Check tightening torque of four back plate bolts
through service hole in hub .
C4-543
Fig. 84
f. Ensure that shoe return spring is installed as shown
in Fig. 85.
Back plate
Shoe guide plate
Retainer
Soring washer
Lever
Primary
L
Secondary shoe
L shoe return
return spring
spring (Blue) (Yellow)
Parking brake shoe
Parking brake shoe
~
(Primary)
(Secondary)
C4-542 ,
Fig . 85
Fig. 87
3) Adjust parking brakes . Refer to 4-4 [W31)1]
.
a . After replacing parking brake lining, be sure to drive
vehicle for "break-in" purposes .
b . Drive the vehicle about 35 km/h (22 MPH).
c. With the parking brake release button pushed in,
pull the parking brake lever gently.
d . Drive the vehicle for about 200 meter (0.12 mile) in
this condition.
e. Wait 5 to 10 minutes for the parking brake to cool
down. Repeat this procedure once more.
f. After breaking-in, re-adjust parking brakes .
44