Table of Contents
Advertisement
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
[T5G2) 3-2
1 . MEASURE SIGNAL VOLTAGE INPUT OF TCU
1) Turn ignition switch ON (with engine OFF) .
2) Measure signal voltage input of TCU .
Connector fr terminal / Specified voltage:
(1367) No. 5 - Body / 10 V, min.
SELECT MONITOR FUNCTION MODE
Mode : 06
Condition :
After warming up the engine
Specified data : EREV F06
(Engine speed is shown in rpm .)
2. CHECK HARNESS BETWEEN TCU AND ECU
(MPFQ.
1) Disconnect connector from TCU .
2) Disconnect connector from ECU .
3) Measure resistance between TCU connector and
ECU connector .
Connector I" r terminal / Specified resistance:
(1367) No. 5- (1361) No. 16 / 0 n
(1367) No. 5- Body / 1 MQ min .
191
Advertisement
Table of Contents
Troubleshooting
