Subaru SVX 1992 Manual page 715

WHEELS AND AXLES [W4B01 4-2
B: DISASSEMBLY
1) Using HUB STAND (28099PA080) and HUB RE-
MOVER "REAR" (28099PA050), remove hub COMPL
from rear housing .
3) Using a standard screwdriver, remove outer and
inner oil seals.
Use new oil seals.
4) Using plier, remove snap ring.
C4-336
Fig. 88
5) Using HOUSING STAND "REAR" (28099PA060) and
BEARING PULLER "REAR" (927100000), remove bear-
ing by pressing inner race .
a. Do not remove bearing unless damaged.
b. Do not re-use bearing after removal.
BEARING INSTALLER "REAR"
(92710 0000)
O
Fig. 86
If inner bearing race remains in the hub, remove it with
a suitable tool (commercially available) .
a. Be careful not to scratch polished area of hub.
b . Be sure to install inner race on the side of outer race
from which it was removed .
2) Remove back plate from rear housing .
HO USTING STAND "REAR"
(28099 PA060)
C4-337]
Fig . 89
Fig . 87
31