Rear Catalytic Converter; Rear Exhaust Pipe - Subaru SVX 1992 Manual

2-9 Iw3B0] EXHAUST SYSTEM
B : INSTALLATION
Installation is in the reverse order of removal procedures.
Observe the following:
1) Be sure to install a new gasket .
2) Use only nuts specified by the manufacturer .
Be sure to install bolts, springs and nuts in the order
indicated in the figure .
Fig. 4
4. Rear Catalytic Converter
B: INSTALLATION
Installation is in the reverse order of removal procedures .
Observe the following:
1) Be sure to install a new gasket .
2) Use only nuts specified by the manufacturer.
Be sure to install bolts, springs and nuts in the order
indicated in the figure.
5. Rear Exhaust Pipe
I B: INSTALLATION
1) Insert rear exhaust pipe bracket into rubber cushion. To
facilitate insertion, apply a coat of SUBARU CRC5-56
(004301003) to the mating area of rubber cushion in
advance.
2) Loosen the seal bearing band and install it over the rear
exhaust pipe in advance.
3) Place the seal bearing between the rear exhaust pipe
and muffler ASSY, and tighten the seal bearing band . Do
not allow clearances to exist between the seal bearing and
rear exhaust pipe, or muffler ASSY while tightening the
band .
Seal bearing band
Rear exhaust
Seal bearing
pipe
Muffler
C2-134
Fig. 6
4) Connect rear exhaust pipe to rear catalytic converter.
Be sure to install bolts, springs and nuts in the order.
< Ref. to 4 Rear Catalytic Converter [W4B0] . >
5) Install rear catalytic converter protector.
Fig . 5