Table of Contents
Advertisement
2-3 [W3E1]
ENGINE
Match
C
/
mark
I
C
\ \
,
v
C
Match
mark
`1'
i
C2-229
Fig. 69
(5) Tighten six bolts of three intake camshaft caps
equally, a little at a time, in the numerical sequence as
illustrated .
Fig . 70
Make sure that, as the bolts are tightened, the clear-
ance between the camshaft journal and the cylinder
head journal decreases evenly at three places . If not,
loosen the bolts by reversing the illustrated numerical
sequence, and then repeat step (5) above.
Fig. 71
(6) Tighten each bolts to the specified torque in the
sequence explained in step (5) .
(7) Remove the sub-gear securing service bolt from
the intake camshaft gear.
Fig . 72
3) Installation of front camshaft cap
(1) Apply fluid packing for mating surface of front
camshaft cover.
Use only enough fluid packing to avoid its entrance
into the camshaft oil hole.
42
Advertisement
Table of Contents
Troubleshooting
