Subaru SVX 1992 Manual page 597

3-3 (WOCO)
TRANSMISSION CONTROL SYSTEM
Fig. 17
OO
c ®5
om
1
Spring
2 Selector lever CP
f777=- 0
3 Boot
4 Lock plate
5 Washer
C3-120
Fig . 20
6) Remove the screw to takeoff the "P" position switch
CID .
"P" position switch CP
0
0
Screw
C3-118
Fig. 18
7) Remove the bolt to take off the selector lever CP
from the plate.
C3-119
Fig. 19
8) Remove the lock plate .
9) Remove the selector lever CP from the plate.
~ C: INSPECTION
1) Inspect the removed parts by comparing with new
ones for deformation, damage and wear . Correct or
replace if defective.
2) Confirm the following parts for operating condition
before ASSY .
(1) Sliding condition of the grip button in the grip . . . it
should move smoothly.
(2) Insertion of the grip on the selector lever . .. when
pushing the grip on the selector lever by hand, the
screw holes should be aligned .
(3) Operation of the selector lever and rod ... they
should move smoothly .
(4) Insertion of the spacer into the selector lever . . . it
should be inserted lightly by finger pressure .
D: ASSEMBLY
1) Clean all parts before assembly .
2) Assemble the selector lever CP and the lock plate to
the plate.
3) Insert the bolt and tighten the flange nut to the
specified torque .
Tightening torque (Flange nut) :
11 - 17 N"m (1 .1 - 1 .7 kg-m, 8 - 12 ft-Ib)
8