Subaru SVX 1992 Manual page 700

4-2 [W1D0j WH EELS AND AXLES
Fig . 32
4) Clean dust or foreign particles from inside the hous-
ing.
5) Using HOUSING STAND (28099PA010) and BEAR-
ING INSTALLER "FRONT" (28099PA000), press a new
bearing into place .
BEARING INSTALLER "FRONT"
(28099 PAOOO)
\
\
t
0
0
0
HOUS91NG STAND "FRONT"
(
09
P
0
S 28099 PA010)
C4-330
Fig. 33
a. Always press outer race when installing bearing.
b. Be careful not to remove plastic lock from inner race
when installing bearing.
c . Charge bearing with new grease when outer race is
not removed .
6) Install snap ring in its groove .
Make sure to install it firmly to groove.
7) Using OIL SEAL INSTALLER "FRONT" (28099PA030)
press inner oil seal until it contacts circlip.
OIL SEAL INSTALLER "FRONT"
(28099 PA030)
*7 HOUSING STAND "FRONT"
(28099 PA010)
C4-331
Fig. 34
8) Turn upper side of HOUSING STAND, housing and
FRONT SEAL INSTALLER down .
9) Using OIL SEAL INSTALLER "FRONT" (28099PA030)
press outer oil seal until it contacts the bottom of
housing .
OI L SEAL INSTALLER "FRONT"
99 PA030)
HOUSING STAND "FRONT"
(28099 PA010)
C4-332
Fig . 35
10) Apply sufficient grease to oil seal lip .
Specified grease :
SHELL 6459N
a . If specified grease is not available, remove bearing
grease and apply Auto Rex A instead .
b. Do not mix different types of grease.
16