Table of Contents
Advertisement
BRAKES
[T5C2] 4-4
1 . CHECK SIGNAL EMITTED FROM SENSOR (ON
ABS CONTROL UNIT SIDE)
1) Disconnect connector from ABS control unit . (Refer
to No. T6A1)
2) Raise all four wheels off ground.
3) Measure voltage between ABS control unit terminals
using a digital circuit tester (set in "AC" range) accord-
ing to trouble code.
2. CHECK SENSOR
1) Disconnect sensor connector .
2) Measure resistance between sensor terminals .
TROUBLE CODE/Connector & Terminal :
5 / Sensor LH No. 1 - No. 2
6 / Sensor RH No. 1 - No. 2
Specified Resistance : 0.8 - 1 .3 ks2
TROUBLE CODE/Connector fr Terminal :
5 / (R7) No. 4 - No. 22
6 / (117) No. 11 - No. 21
Specified Voltage :
200 - 300 mV (at "creep" speed of AT model)
4) Disconnect ABS control unit connector, and mea-
sure resistance between sensor and ground.
Connector & terminal/Specified Resistance:
(R7) No. 22 - Body/1 Mfg min .
(R7) No. 21 - Body/1 MQ min.
3) Measure resistance between sensor connector ter-
minal and ground .
a
S2
I 2
B 3
Sensor side
04-748
Fig . 165
Connector £r terminal/Specified Resistance:
(B18) No. 1 - Body/1 Mfg min .
(B3) No . 1 - Body/1 MQ min.
83
Advertisement
Table of Contents
Troubleshooting
