Subaru SVX 1992 Manual page 316

FUEL INJECTION SYSTEM
[T9G2] 2-7
1 . CHECK INPUT SIGNAL FOR ECU.
1) Turn ignition switch to "ON" .
2) Measure voltage between ECU connector terminals
and body.
Connector ft Terminal/Specified voltage
(1360) No. 11 - Body/10 - 13 V
(1360) No . 5 - Body/0 - 0.3 V
(1360) No. 6 - Body/0 - 0 V
3) Measure voltage between ECU connector terminals
and body on engine idling .
Connector £r Terminal/Specified voltage
(1360) No . 11 - Body/13 - 14 V
(1360) No . 5 - Body/0 .8 - 1 .2 V
(1360) No . 6 - Body/0 - 0 V
2. CHECK HARNESS CONNECTOR BETWEEN
ECU AND AIR FLOW SENSOR .
1) Turn ignition switch to "OFF".
2) Disconnect connector from ECU and air flow sensor .
3) Measure resistance of harness connector between
ECU and air flow sensor .
Connector £r Terminal/Specified resistance
(1360) No. 11 - (131) No . 5/0 0
(1360) No . 4 - (131) No. 3/0 i2
(1360) No. 5 - (131) No. 2/0 f2
(1360) No . 6 - (131) No. 1/0 0
1360
Ei 123456
1 23j~45 789101112
C2-356
Fig. 72
69