Subaru SVX 1992 Manual page 120

ENGIN E AND TRANSMISSION MOUNTING SYSTEM Iw3B0) 2-11
B : INSTALLATION
Installation is in the reverse order of removal.
1) Install cushion rubber onto lower side of engine
block.
riy. -+i
Tightening torque : N"m (kg-m, ft-Ib)
20-33 (2-3 .4, 14-25)
. ly . -+z_
3) Tighten bolts which install cushion rubber onto sub-
frame .
Tightening torque : Nom (kg-m, ft-Ib)
54-83(5.5-8 .5,40-61)
4) Install stabilizer ASSY .
(1) Install stabilizer CP, and temporarily tighten bolts
which install stabilizer clump onto sub-frame.
(2) Install stabilizer lever to stabilizer CP .
Align the point mark between stabilizer CP and lever.
Stabilizer lever
Marking
y
Lower arm
C4-109
Fig . 43
Tightening torque : N"m (kg-m, ft-Ib)
45-58(4.6-5 .9,33.2-42.8)
(3) Install stabilizer link to stabilizer lever.
Tightening torque : N"m (kg-m, ft-Ib)
32-42 (3 .3-4.3, 23 .6-31 .0)
(4) Tighten stabilizer clump installing bolts .
Tightening torque : N-m (kg-m, ft-Ib)
21-29(2.1-3.0,15.5-21.4)
(5) Install right side brake hose and ABS sensor
harness on strut .
17
2) Lower engine down onto sub-frame.
Make sure that the cushion rubber locator is in the
elliptical hole in sub-frame.