Subaru SVX 1992 Manual page 724

4-2 [W6B0]
WHEELS AND AXLES
17) Remove DOJ inner race assembly from shaft .
fig . 7 2/
Be sure to wrap shaft splines with vinyl tape to prevent
boot from scratches.
18) Remove DOJ boot.
19) Remove BJ boot band protector .
Hg. 728
20) Remove BJ boot band .
Mg. 7 Z9
21) Remove BJ boot .
FB- INSPECTION
Check the removed parts for damage, wear, corrosion,
etc. If faulty, repair or replace .
1) DOJ (Double Offset Joint) and BJ (Bell Joint)
Check seizure, corrosion, damage, wear and excessive
play .
2) Shaft
Check excessive bending, twisting, damage and wear.
3) Boot
Check for wear, warping, breakage or scratches .
4) Grease
Check for discoloration or fluidity .
C : INSTALLATION
Use specified grease .
BJ and DOJ :
Molylex No. 2 (P/N 723223010) or Sunlight TB2-A
Be sure to wrap shaft splines with vinyl tape to prevent
boot from scratches.
1) Install BJ boot in specified position, and fill it with 60
to 70 g (2 .12 to 2 .47 oz) of specified grease .
2) Place boot band protector and DOJ boot at the
center of shaft .
3) Insert DOJ cage onto shaft .
Insert the cage with the cut-out side facing the shaft
end, since the cage has an orientation.
Fig. 730
40