Table of Contents
Advertisement
3- 2 [w11Ao]
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
11 . Forward Clutch Drum
A: DISASSEMBLY
1) Remove two snap rings from the forward clutch
drum .
Fig . 251
2) Remove the retaining plate, drive plates, driven
plates and dish plate. (Forward clutch)
3) Remove the snap ring from the forward clutch drum .
Fig . 252
4) Remove the retaining plate, drive plates, driven
plates and dish plate. (Overrunning clutch)
5) Compress the spring retainer, and remove the snap
ring from the
forward
clutch,
by
using
SEAT
(498627100) and COMPRESSOR (398673600) .
6) Install the one-way clutch inner race to the forward
clutch drum, and apply compressed air to remove the
overrunning piston and forward piston .
Fig. 253
7) Remove the one-way clutch after taking out the snap
ring.
8) Remove the needle bearing after taking out the snap
ring .
B: INSPECTION
1) Drive plate facing for wear and damage
2) Snap ring for wear, return spring for setting and
breakage, and snap ring retainer for deformation
3) Lip seal and lathe cut ring for damage
4) Piston and drum check ball for operation
160
Advertisement
Table of Contents
Troubleshooting
