Subaru SVX 1992 Manual page 783

STEERING SYSTEM [w4C1] 4-3
C: ASSEMBLY
1 . ENGINE SPEED SENSING TYPE
1) Wash and clean pinion £r valve ASSY and valve
housing .
2) Attach COVER to pinion ASSY, and apply grease to
outer perimeter of the cover and mating surface of oil
seal .
COVER
(926270000)
t xxxxxxrxxxxxxxxx
xxxx
Xxxxxxxxxx"
- Grease
84-974
Fig. 121
3) Apply a coat of grease to spacer and sealing lips of
oil seal, and install spacer and oil seal .
a . Face chamfered side of spacer toward oil seal .
b. Face oil seal in correct direction.
Spacer Oil seal
84-975
O-ring
Seal ring
I
C441i
I
40101111
COVER
(926450000)
04-291
Fig. 123
5) Apply a coat of grease to inner wall of FORMER, and
secure seal ring assembled in step (9) as shown. Leave
seal ring unattended for approximately 10 minutes until
it settles down .
Seal ring
FORMER
(926280000)
l©
O-ring
134-977
Fig . 124
6) While aligning valve sleeve pin with groove on pin-
ion ASSY, secure with snap ring .
a. Be careful not to damage inner wall of valve sleeve
and contact surface of pinion .
b. Align pinion groove with pin using alignment mark.
c . Before assembling valve sleeve and pinion ASSY,
clean in kerosene and dry with compressed air .
Fig . 122
4) Install COVER to input shaft, and apply a coat of
grease to the cover surface. Install O-ring and seal ring .
Do not expand O-ring and seal ring more than neces-
sary .
53