Table of Contents
Advertisement
2-11 [w2AO]
ENGINE AND TRAN SMISSION MOUNTING SYSTEM
1) Set the vehicle on lift arms .
2) Move damper, and open front hood fully.
Refer to C.1-3.
3) Release fuel pressure .
(1) Disconnect fuel pump connector.
(2) Start the engine, and run until it stalls .
(3) After the engine stalls, crank it for more five
seconds .
(4) Turn ignition switch "OFF".
Refer to C.2-8 Section 1 [W101] .
4) Disconnect battery ground cable .
5) Remove under cover, and drain coolant .
(1) Raise the vehicle .
(71 RPmnvp under rnvar
6) Remove cooling system .
(1) Disconnect radiator outlet hose from thermostat .
(21 Disconnect ATF cooler hoses from nines .
. .y .
,y . .,
(6) Disconnect radiator main fan and sub-fan con-
nector .
(7) Remove upper bracket, and remove radiator
ASSY from vehicle .
I
"`
""x'"'11
'
C2-014
Fig . 7
7) Collect refrigerant, and remove pressure hoses.
6
(3) Lower the vehicle.
(4) Remove V-belt cover.
(5) Disconnect radiator inlet hose from water nine .
(3) Fit one end of vinyl tube into drain pipe .
141 I nnsPn drain r-nrk and rlrain nnnlant
Drain coolant into container.
Advertisement
Table of Contents
Troubleshooting
