Table of Contents
Advertisement
BRAKES
[T5132] 4-4
1 . CHECK HYDRAULIC UNIT SOLENOID
1) Turn ignition switch ON .
2) Ground check-connector terminal, and check sole-
noid valve for operation (sound which indicates proper
operation) .
Each time solenoid activates, system circuit is inter-
rupted . To check again, first turn ignition switch OFF
and then ON.
TROUBLE CODE/Connector £r Terminal :
1 / (B34) No . 2 - Body
2 / (B34) No . 11 - Body
3 / (B34) No. 12 - Body
4 / (B34) No. 3 - Body
Fig. 163
2. CHECK SOLENOID (ON ABS CONTROL UNIT
SIDE)
1) Turn ignition switch ON .
2) Attach circuit tester's positive probe to terminal (cor-
responding with solenoid) and ground probe to ground
and measure voltage between terminal and ground .
Each time solenoid activates, system circuit is inter-
rupted . To check again, first turn ignition switch OFF
and then ON.
TROUBLE CODE/Connector & Terminal :
1 / (R7) No. 2 - Body
2 / (R7) No. 35 - Body
3 / (R7) No. 19 - Body
4 / (R7) No. 18 - Body
Specified Voltage: 0 V (solenoid in operation)
81
Advertisement
Table of Contents
Troubleshooting
