Subaru SVX 1992 Manual page 773

STEERING SYSTEM [w3EoI 4-3
Face oil seal in the direction shown in Figure 82.
INSTALLER B
(34099PA040) INSTALLER A
INSTALLER C,
(34099PA030)
L Oil seal
Rack ASSY
Installer A
04-293
Fig . 82
(3) Install back-up ring from gear side of rack ASSY .
INSTALLER C (927490000) is furnished with INSTALL-
ERS B and C as a tool set for use on all Legacy models .
'
Oil seal Back-up ring
d'
on
Rack ASSY
84-992
Fig. 83
(4) Apply a coat of grease to grooves in rack, sliding
surface of sleeve and sealing surface of piston . Then
insert rack ASSY into steering body ASSY from
cylinder side .
a. Be sure to apply grease so that it covers the entire
surface of rack gear teeth.
b . Do not allow grease to block air vent hole on rack.
Cylinder side of
steering body ASSY
Rack ASSY
-,
- e
uy
/-Back-up ring
I
C4-080
(5) Installation of holder ASSY
Attach GUIDE to rack ASSY to prevent scratching
cylinder, and apply a thin coat of grease to rack ASSY
and GUIDE.
Fig. 85
(6) Apply a coat of grease to inner wall of holder
ASSY and O-ring, and install holder ASSY on steering
body ASSY .
a. Ensure that guide is free from scratches . Scratches
may damage oil seal .
b. Be careful not to damage oil seal lips when install-
ing holder ASSY.
-Holder ASSY
Oil seal
F_~_O-ring
GUIDE RACK
(34099PA020)
----^r Holder ASSY
Pin hole
04-082
Fig . 86
(7) Apply a coat of grease to snap ring, and insert
into groove in steering body ASSY. Secure holder
ASSY.
Ensure that both ends of snap ring are close to pin hole
when installed.
(8) Attach INSTALLER to rack ASSY's cylinder . Using
a press, install back-up ring and oil seal .
Press INSTALLER until its groove is aligned with end of
holder ASSY.
Fig. 84
43