Subaru SVX 1992 Manual page 866

4-4 [W1F0) BRAKES
7) Apply a coat of specified grease to guide pin outer
surface, sleeve outer surface, cylinder inner surface and
boot grooves .
Grease :
RUBBER GREASE or NIGLUSE RX-2
1= : INSTALLATION
1) Install disc rotor on housing .
2) Install support on housing .
a. Always replace the pads for both the left and right
wheels at the same time. Also replace pad clips if they
are twisted or worn.
b . A wear indicator is provided on the outer disc brake
pad . If the pad wears down to such an extent that the
end of the wear indicator contacts the disc rotor, a
squeaking sound is produced as the wheel rotates. If
this sound is heard, replace the pad .
c. When replacing the pad, replace pads of the right
and left wheels at the same time.
3) Apply thin coat of PBC GREASE (725191330 or
003607000) to the frictional portion between pad and
pad clip .
4) Install pads, rubber coated shim and stainless shim
on support .
Guide pin
Outer pad
Shim fRubber coating)
~ d
Shim (Stainless)
Shim
A(Rubber~
Pad clip
coating)
Inner pad
add mmust bbe installed
Pp
with the clip of pad facing
lower side of vehicle .
84-371
Fig. 59
5) Install caliper body on support.
6) Connect brake hose .
7) Bleed air from brake system .
36
Fig . 57 Grease application to guide pin portion
Fig . 58 Grease application to lock pin portion
8) Install guide pin boot on caliper body .
9) Install lock pin boot on caliper body and insert lock
pin sleeve into place.