Subaru SVX 1992 Manual page 490

3- 2 [W2C2] AUTOMATIC TRANSMISSION AND DIFFERENTIAL
Ng . 7 UU
(6) Install oil pan £r gasket .
Tightening torque :
3.4 - 4.4 N"m (0.35 - 0 .45 kg-m, 2.5 - 3 .3 ft-Ib)
Forward direction I,~
f
~I I
~y 0 ` -` ATF drain plug
C3-055
Fig. 101
(7) Add and check ATF .
2. DUTY SOLENOID C AND TRANSFER VALVE
BODY
1) Removal
(1) Remove pitching stopper.
(2) Remove OZ sensor connector from bracket, and
disconnect 02 sensor connector.
a . Be sure not to damage 02 sensor connector and
harness.
(3) Raise car and drain ATF.
(4) Remove front exhaust pipe and rear exhaust pipe
with center catalyst .
For removal of exhaust system, refer to "2-9 EXHAUST
SYSTEM" [W3A0] [W4A0].
a. Be sure not to damage OZ sensor harness when
removing front exhaust pipe.
(5) Remove front exhaust cover.
(6) Remove propeller shaft .
For removal of propeller shaft, refer to "3-4 AWD
SYSTEM" [W1B0] .
Before removing propeller shaft, scribe alignment
marks on propeller shaft and rear differential coupling .
a. Be sure not to bend propeller shaft when removing .
Before removing propeller shaft, wrap metal parts
(installed at the rubber boot of center DOJ) with a
cloth or rubbered material . Rubber boot may be dam-
aged due to interference with adjacent metal parts
while bending the DOJ during removal .
b. Be sure to use an empty oil can to catch oil flowing
out when removing propeller shaft.
c. Be sure not to damage oil seals and the frictional
surface of sleeve yoke.
d. Be sure to plug the opening in transmission after
removal of propeller shaft.
(7) Remove rear crossmember .
" Support transmission using a transmission jack and
raise slightly.
" Remove bolts and nuts as shown in Figure 103.
Fig. 102 1-1g . 7 U3
116