Subaru SVX 1992 Manual page 720

4-2 [W5C0] WHEELS AND AXLES
6) Insert DOJ spline end into bore of side oil seal, and
remove SIDE OIL SEAL PROTECTOR .
Do not allow DOJ splines to damage side oil seal .
Ng . 7 7 U
C: DISASSEMBLY
1) Remove DOJ boot band.
Be careful not to damage boot .
7) Align DOJ and differential splines .
8) Push housing to insert DOJ into differential .
Make sure DOJ is inserted properly.
t-1g. 7 7 7
9) Install remaining parts in reverse order of removal .
10) For installation and tightening torque of suspension
parts, refer to 4-1 [C200] .
For installation and tightening torque of brake parts,
refer to 4-4 [C200] .
a. Use a new self-lock nut.
b. Always tighten axle nut before installing wheel on
vehicle. If wheel is installed and comes in contact with
ground when axle nut is loose, wheel bearings may be
damaged.
c. Be sure to tighten axle nut to specified torque . Do
not overtighten it as this may damage wheel bearing.
11) After tightening axle nut, lock it securely .
-/g. 772
2) Remove boot from DOJ .
3) Remove circlip from DOJ outer race using screw-
driver .
i
B4-615
Fig . 113
4) Take out DOJ outer race from shaft ASSY .
1 Outer race
2 Grease
I B4-616
Fig. 114
36