Subaru SVX 1992 Manual page 629

AWD SYSTEM [W2Do] 3-4
PULLER SET
(399527700)
B3-1651
REPLACER
Rear bearing cone
(398517700)
B3-169
Fig . 59
13) Remove front oil seal from differential carrier .
14) Remove pilot bearing together with front bearing
cone .
DRIFT (398467700)
Rear bearing cup , Pilot bearing
Front bearing
. ., . _.
I
B3-170I
Further disassembling is not allowed.
Fig. 60
9) Hold companion flange with FLANGE WRENCH and
remove drive pinion nut.
15) When replacing bearings, tap front bearing cup and
10) Extract the companion flange with a puller .
rear bearing cup in this order out of case by using a
11) Press the end of drive pinion shaft and extract it
brass bar.
together with rear bearing cone, preload adjusting
spacer and washer .
Hold the drive pinion so as not to drop it.
LDRIFT (398467700)
I-
B3-168
Groove width :
12 nom (0 .47 in)
O
i
Tap alternately with brass bar.
B3-171
Fig . 61
Fig . 58
12) Remove rear bearing cone from drive pinion by
supporting cone with REPLACER .
Place the replacer so that its center-recessed side faces
the pinion gear.
23
Fig. 56
81 Remove drive aear by loosenina drive clear bolts .