Subaru SVX 1992 Manual page 722

4-2 [W5E0]
WHEELS AND AXLES
6) Fill 80 to 90 g (2 .82 to 3 .17 oz) of specified grease
into the interior of DOJ outer race.
7) Apply a coat of specified grease to the cage pocket
and six balls .
8) Insert six balls into the cage pocket .
9) Align the outer race track and ball positions and
place in the part where shaft, inner race, cage and balls
are previously installed, and then fit outer race.
1 Outer race
2 Grease
14) Pinch the end of band with pliers. Hold the clip and
tighten securely.
When tightening boot, exercise care so that the air
within the boot is appropriate.
15) Tighten band by using BAND TIGHTENING TOOL
(925091000) .
a . Tighten band until it cannot be moved by hand .
b. Former BAND TIGHTENING TOOL (925090000) is
interchangeable with this 925091000.
BAND TIGHTENING TOOL
(92509 0000)
B4-616
Fig. 118
10) Install circlip in the groove on DOJ outer race .
a . Assure that the balls, cage and inner race are com-
pletely fitted in the outer race of DOJ .
b. Exercise care not to place the matched position of
circlip in the ball groove of outer race.
c. Pull the shaft lightly and assure that the circlip is
completely fitted in the groove .
u
84-615
Fig . 119
11) Apply an even coat of the specified grease [20 to 30
g (0 .71 to 1 .06 oz)] to the entire inner surface of boot .
Also apply grease to shaft.
12) Install DOJ boot taking care not to twist it.
a. The inside of the larger end of DOJ boot and the
boot groove shall be cleaned so as to be free from
grease and other substances .
b. When installing DOJ boot, position outer race of
DOJ at center of its travel .
13) Put a band through the clip and wind twice in
alignment with band groove of boot .
Use a new band .
C4-197
Fig . 120
16) Tap on the clip with the punch provided at the end
of BAND TIGHTENING TOOL .
Tap to an extent that the boot underneath is not
damaged.
l-
C4-19a
Fig . 121
17) Cut off band with an allowance of about 10 mm
(0 .39 in) left from the clip and bend this allowance over
the clip.
Be careful so that the end of the band is in close
contact with clip.
18) Fix up boot on BJ in the same manner .
19) Install protector onto BJ boot band .
Extend and retract DOJ to provide equal grease coat-
ing.
38