Subaru SVX 1992 Manual page 795

STEERING SYSTEM
IW6Fo) 4-3
Hand press
INSTALLER
19269700001
oil seal
Front body
w
134-1009
Fig. 157
2) Installation of drive shaft
(1) Using GUIDE and a hand press, drive bearing
onto shaft.
Hard press
`~
Shaft
Bearing
_GUIDE
(926980000)
T
s4-1010
Fig . 158
(2) Install retaining ring on oil seal . Using GUIDE,
press shaft ft bearing ASSY into front body .
a. Be careful not to strike shaft splines on oil seal's
sealing lips during installation.
b. Do not hit end of shaft during installation.
GUIDE
(926980000)
Shaft & bearing ASSY
Retaining ring
Front body
B4-1011
Fig . 159
(3) Lock drive shaft using a retaining ring.
3) Installation of pressure plate
Place front body in a vise with pulley side facing down .
Position two 0-rings and pressure plate in front body in
that order.
Do not forget to install 0-rings.
4) Installation of cartridge
(1) Install cam, rotor and vane in that order.
(2) Insert pin into holes in cam and pressure plate .
a. Ensure that vane is installed with "R" side facing
the cam.
b. Check that vane moves smoothly .
c. Apply a coat of automatic transmission fluid
(DEXRON II) to vane.
5) Installation of rear body
(1) While aligning pin hole of rear body with pin on
the pump, install rear body using a gasket and tighten
bolts by hand.
(2) Remove pump from vise .
(3) Place pump bracket in a vise, install pump on
pump bracket.
(4) Tighten rear body mounting bolts in a criss-cross
fashion to one-half of specified torque, then tighten
to specified torque .
After tightening rear body mounting bolts, ensure that
shaft rotates properly .
0
r
4 0
I C~
1 \ m
04-254
Fig . 160
6) Installation of valve
(1) Position spring and valve ASSY in front body in
that order.
(2) Connect connector to front body with an O-ring in
place.
Tightening torque :
29 - 39 N" m (3.0 - 4 .0 kg-m, 22 - 29 ft-lb)
FF: INSTALLATION
To install, reverse the order of removal procedures.
Replenish specified fluid and purge air .
Do not operate engine before replenishing fluid as this
will seize oil pump.
65