Subaru SVX 1992 Manual page 523

AUTOMATIC TRANSMISSION AND DIFFERENTIAL [W4B7] 3- 2
(4) With hole aligned, tighten three bolts to secure
the inhibitor switch .
Tightening torque :
2.9 - 3.9 Nam (0.30 - 0 .40 kg-m, 2.2 - 2.9 ft-Ib)
3) Connect the following cords and harness to bracket.
(1) Transmission harness
(2) Inhibitor switch cord
(3) Vehicle speed sensor 1 cord
4) Install the oil cooler outlet pipe .
Tightening torque :
27 .5 - 34 .3 Nam (2.80 - 3.50 kg-m, 20.3 - 25 .3
ft-Ib)
5) Install the oil cooler inlet pipe .
Tightening torque :
23 - 26 Nam (2 .3 - 2.7 kg-m, 17 - 20 ft-Ib)
Be sure to use a new aluminum washer .
6) Install the oil charge pipe.
Tightening torque : Nam (kg-m, ft-Ib)
UPPER
34-40(3.5-4 .1,25-30)
LOWER
5.9-6.9(0 .60-0.70,4.3-5 .1)
Be careful not to damage the O-ring.
7) Adjustment of brake band :
(1) After tightening the brake band adjusting screw
to 9 Nam (0 .9 kg-m, 6.5 ft-Ib) torque, back it off three
turns . Then secure with a lock nut.
Tightening torque :
25 - 28 Nam (2.5 - 2.9 kg-m, 18 - 21 ft-Ib)
When tightening the lock nut, be careful not to turn the
adjusting screw.
8) Install the pitching stopper bracket.
Tightening torque :
36 - 42 Nam (3.7 - 4.3 kg-m, 27 - 31 ft-Ib)
Tightening torque : Nam (kg-m, ft-Ib)
Diff.
41 -47 (4.2-4 .8, 30-35)
ATF
23 - 26 (2.3 - 2.7, 17 - 20)
10) Install the air breather hose .
11) Insert the input shaft while turning lightly by hand .
Be careful not to damage the bushing .
Input shaft
~I I
Normal protrusion-~ \\\ `
28 - 33 mm (1 .10 - 1 .30 i n
C3-078
Fig. 222
12) Install the torque converter assembly .
(1) Install the oil pump shaft to the torque converter.
Make sure the clip fits securely in its groove .
(2) Holding the torque converter assembly by hand,
carefully install it to the converter case . Be careful not
to damage the bushing . Also, to avoid undue contact
between the oil pump shaft bushing and stator shaft
portion of the oil pump cover.
(3) Rotate the shaft lightly by hand to engage the
splines securely .
13) Add oil :
Specified quantity C (US qt, Imp qt)
D iff.
1 .3-1 .5(1 .4-1 .6,1 .1-1 .3)
ATF
9.5-9 .8(10.0-10 .4,8 .4-8 .6)
After adding oil, insert the oil level gauge into the oil
inlet.
9) Tighten the drain plugs .
149