Subaru SVX 1992 Manual page 539

AUTOMATIC TRANSMISSION AND DIFFERENTIAL
[w14CO] 3- 2
14. Differential Case Assembly
[ A: DISASSEMBLY
1) Using a press, remove the taper roller bearing.
Be careful not to damage the speedometer drive gear .
Fig. 263
2) Secure the case in a vise and remove the crown gear
tightening bolts, then separate the crown gear, case
(RH) and case (LH) .
-
-rown gear
Differential
case (RH)
11-1
Differential case (LH)
B3-399
Fig . 264
3) Pull out the straight pin and shaft, and remove the
differential bevel gear, washer, and differential bevel
pinion .
Fig. 265
B: INSPECTION
Check each component for harmful cuts, damage and
other faults .
C : ASSEMBLY
1) Install the washer, differential bevel gear and differ-
ential bevel pinion in the differential case (RN) . Insert the
pinion shaft, and fit the straight pin.
Make sure that the case (RH) is staked in order to lock
the straight pin.
2) Install the washer and differential bevel gear to the
differential case (LH) . Then put the case over the differ-
ential case (RH), and connect both cases .
3) Install the crown gear and secure by tightening the
bolt.
Standard tightening torque :
59 - 65 Nom (6.0 - 6.6 kg-m, 43 - 48 ft-Ib)
4) Measurement of backlash (Selection of washer) .
Measure the gear backlash by inserting a dial gauge
through the access window of the case.
Standard value:
0.13 - 0.18 mm (0 .0051 - 0.0071 in)
Measure the backlash by applying a pinion tooth be-
tween two bevel gear teeth.
165