Subaru SVX 1992 Manual page 931

PEDAL SYSTEM AND CONTROL CABLES [W1 1321 4-5
~
B: REMOVAL
1 . ACCELERATOR PEDAL ASSY TOGETHER
WITH ACCELERATOR CABLE
1) Disconnect ground cable from battery .
2) Remove collector cover, and disconnect accelerator
cable from throttle body and holder .
ul11111hmllfill I1[111]fllifill_li-
r
._, I l i l ~- : d i l l .
~~ I11111111lIIl1IJl11111 II Illllll llllllllallllla~al~~~ _
Acce le r ator cable -
C4-095
Fig . 4
3) Remove lower instrument cover and lower instru-
ment cover panel located under steering column .
4) If necessary, remove steering shaft ASSY . (Ref. to
[4-3] No. W 1 A0)
5) Remove bolts which secure pedal bracket.
i
/,
i
I! i
m-7S
1
I , I I-=
C4-094
Fig. 5
6) Disconnect grommet from toe board, and remove
accelerator pedal and bracket together with accelerator
cable.
7) Remove bushing and cable stopper from front end
of accelerator pedal.
While using a standard screw driver or a suitable tool to
rear of bushing, lever off bushing and cable stopper.
Bushing
-
Cable stopper
C4-096
Fig. 6
2. BRAKE PEDAL ASSY
(After removal of accelerator pedal ASSY.)
1) Remove steering shaft ASSY. (Ref . to [4-3]
No .W1 A0)
2) Remove front seat ASSY .
3) Disconnect TCU and ECU connectors, and remove
TCU and ECU .
4) Disconnect stop lamp connector .
5) Remove snap pin which connects brake pedal and
operating rod.
Operating rod length is preset at the factory . Do not
attempt to loosen the lock nut.
5