Table of Contents
Advertisement
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
[W8C0I 3- 2
rig. Z40
3) After fitting the O-ring to the shaft, attach the drive
pinion collar to the shaft. Be careful not to damage the
O-ring .
4) Tighten the lock washer and lock nut.
Actual tightening torque :
108 - 118 N"m (11 .0 - 12 .0 kg-m, 80 - 87 ft-Ib)
a. Pay attention to the orientation of lock washer.
b . When using special tool WRENCH (499787100) and
torque wrench, tighten it to 88 N "m (9 kg-m, 65 ft-Ib) .
rig. Z4u
5) Measure the starting torque of the bearing .
Make sure the starting torque is within the specified
range . If out of the allowable range, replace the roller
bearing .
Starting torque :
0 .3 - 2.0 Nom (3 - 20 kg-m, 2.6 - 17.4 ft-Ib)
Fig . 247
6) Stake the lock nut securely at two places .
7) Measure dimension "B" of the drive pinion shaft.
Fig. 248
8) Determine the thickness t (mm) of the drive pinion
shim .
t= 6.5-(B-A)
The number of shims must be three or less.
Available drive pinion shims
Part No .
Thickness mm (in)
31451AA050
0 .15
(0.0059)
31451AA060
0 .175
(0.0069)
31451AA070
0 .2
(0 .008)
31451AA080
0 .225
(0.0089)
31451AA090
0 .25
(0.0098)
31451AA100
0.275
(0 .0108)
157
Advertisement
Table of Contents
Troubleshooting
