Table of Contents
Advertisement
AUTOMATIC TRANSMISSION AND DIFFERENTIAL
[w4A31 3- 2
CT
Snap ring
133-289
I
B3-291
24) Take out the low Fr reverse brake section .
Fig .
157
Remove the snap ring . Then remove the retaining
plate, drive plates, driven plates, and dish plates as a
25) After removing the snap ring (inner), take out the
unit.
servo piston by applying compressed air from the
release pressure side .
Hold the servo piston with a rag so that it will not be
ejected with the air pressure. In this case, do not allow
your finger to be pinched between the pipe and re-
tainer .
131
771 T ..1... .. . .a sL ... ... .....- . . .,. .- . .-_ _L .a-L L. .L
Fig. 155
Turning the case upside down, take out the one-way
0 Take out the low ft reverse piston by applying com-
------J - :-
Advertisement
Table of Contents
Troubleshooting
