Subaru SVX 1992 Manual page 522

3- 2 [W4B7] AUTOMATIC TRANSMISSION AND DIFFERENTIAL
L : Distance from end of extension case to end of
rear drive shaft.
0.4 : Gasket thickness
P : Height from end of transmission case to end of
reduction drive gear .
Select suitable thrust needle bearing from among
those listed in the following table to adjust clearance
in the 0.50 - 0.2 mm (0 .0197 - 0.0079 in) range.
AWD: Thrust needle bearing
Part No. Thickness mm (in)
806535020
3 .8 (0.150)
806535030 4 .0 (0.157)
806535040 4 .2 (0.165)
806535050 4.4 (0.173)
806535060 4 .6 (0.181)
806535070
4 .8 (0.189)
806535090 5 .0 (0.197)
Select from one to five shims so that clearance is
within specifications .
5) Installation of extension case and transmission case .
AWD model :
(1) Attach the selected thrust needle bearing to the
end- surface of reduction drive gear with vaseline .
(2) Set the parking return spring .
(3) Remove the transfer clutch from the extension
case .
Set the needle bearing on the reduction drive shaft
and then install transfer clutch to the transfer clutch
hub. Be sure to engage the spline teeth correctly.
(4) With gasket inserted between them, install the
extension case to the transmission case . (Be sure to
use a new gasket .)
a . After inserting the extension case halfway, connect
the connector for duty sol . C. Be careful not to jam the
cord in the case .
b. Be careful not to damage the rear drive shaft seal
ring.
(5) Tighten bolts to secure the case .
Tightening torque :
23 - 26 N"m (2.3 - 2.7 kg-m, 17 - 20 ft-Ib)
7 . EXTERNAL PARTS
1) Install the vehicle speed sensor 1 .
Tightening torque :
6 - 8 N "m (0.6 - 0.8 kg-m, 4.3 - 5.8 ft-Ib)
2) Installation and adjustment of inhibitor switch :
(1) Install the inhibitor switch to the transmission
case . Fit the projecting portion of the switch in the
recessed portion of the case, and tighten three bolts
temporarily.
(2) Insert the range selector lever into the shaft, and
tighten the nut.
Tightening torque :
36 - 42 N-m (3 .7 - 4.3 kg-m, 27 - 31 ft-Ib)
y
0
U
u
- Range select lever
I
o 0
o vy
0
-U
I
I
B3-354
Fig. 22o
(3) With the selector lever set to "N" adjust the
inhibitor switch so that the hole of range selector
lever is aligned with the inhibitor switch hole .
Ensure that gauge moves properly .
Fig . 221
148