Table of Contents
Advertisement
4-2 [W3CO]
WHEELS AND AXLES
15) Tap on the clip with the punch provided at the end
of BAND TIGHTENING TOOL.
Tap gently so that the boot underneath is not dam-
aged .
C4-344
Fig. 70
16) Cut off band with an allowance of about 10 mm
(0 .39 in) left from the clip and bend this allowance over
the clip .
Make sure that the end of the band is in close contact
with clip.
17) Fix boot on BJ in the same manner .
Extend and retract FTJ to provide equal grease coat-
ing .
18) Install remaining parts in reverse order of removal.
For installation and tightening torque of suspension
parts, refer to 4-1 [C1001 .
For installation and tightening torque of brake parts,
refer to 4-4 [C100] .
a . Use a new self-locking nut.
b. Make sure O-ring is properly installed on transmis-
sion spindle.
c. Apply a sufficient coat of grease to transmission
spindle splines .
d. Always use new sealer-pack type spring pin .
26
Advertisement
Table of Contents
Troubleshooting
