Subaru SVX 1992 Manual page 536

3- 2 pi 1Col AUTOMATIC TRANSMISSION AND DIFFERENTIAL
Part No.
Thickness mm (in)
31567AA010
8 .0 (0 .315)
31567AA060 8 .2 (0 .323)
31567AA070 8 .4 (0 .331)
31567AA080 8 .6 (0 .339)
31567AA090 8 .8 (0 .346)
31567AA100
9 .0 (0 .354)
rig. Z,')/
4) Install the dish plates, driven plates, drive plates, and
retaining plate, and secure with the snap ring . (Forward
clutch)
Pay attention to the orientation of the dish plate.
Snap ring
Dish plate
I
Outer vace side
133-393
Fig . 258
5) Install the snap ring (for front planetary carrier) .
6) Check the forward clutch and overrunning clutch for
operation .
Set the one-way clutch inner race, and apply com-
pressed air for checking .
7) Checking clearance :
Standard value Allowable limit
mm (in) mm (in)
Forward clutch
0 .45-0.85
(0 .0177 - 0.0335)
1,6 (0 .063)
Overrunning clutch
1 .0-1 .4
(0 .039 - 0.055)
2 .0 (0 .079)
Before measuring clearance, place the same thickness
of shim on both sides to prevent retaining plate from
tilting.
If the clearance is out of the specified range, select a
proper retaining plate so that the standard clearance
can be obtained .
(Forward clutch)
(Overrunning clutch)
Part No. Thickness mm (in)
31567AA120 8.0 (0 .315)
31567AAl30 8 .2 (0 .323)
31567AA140 8 .4 (0 .331)
31567AA150 8 .6 (0 .339)
31567AA160 8 .8 (0 .346)
31567AA170 9 .0 (0 .354)
31567AA180 9 .2 (0 .362)
8) Install the needle bearing, and secure with the snap
ring .
` Snap ring
Needle bearing
I I I I
133-394
Fig. 259
9) Install the one-way clutch (1-2) and plate, and secure
with the snap ring .
Set the inner race. Make sure that the forward clutch is
free in the clockwise direction and locked in the coun-
terclockwise direction, as viewed from the front of the
vehicle.
Locked Free
One-way clutch
inner race
(Locked)
Forward ~J
clutch drum
I 'i~ tJ . .
i
. : . ASS:
:: .
B3-395
Fig . 260
162