Subaru SVX 1992 Manual page 116

ENGINE AND TRANSMISSION MOUNTING SYSTEM Iw2 .Bol 2-11
1) Install engine to transmission .
Position engine in engine compartment and align it with
transmission .
Be careful not to damage adjacent parts or body
panels with crank pulley, oil pressure gauge, etc.
2) Tighten bolts which hold right upper side of engine
to transmission .
Tightening torque : N "m (kg-m, ft-Ib)
46 - 54 (4 .7 - 5.5, 34 - 40)
3) Remove lifting device and wire ropes.
4) Remove garage jack .
5) Install pitching stopper on to bracket.
Tightening torque : N "m (kg-m, ft-Ib)
44 - 54 (4 .5 - 5.5, 33 - 40)
6) Install torque converter to drive plate .
(1) Tighten bolts which install torque converter to
drive plate.
Be careful not to drop bolts into torque converter
housing.
Tightening torque : N "m (kg-m, ft-Ib)
23-26 (2 .3-2 .7, 17-20)
(2) Clog plug onto service hole .
7) Connect hoses.
Fuel delivery hose, return hose and evaporation
hose
Heater inlet and outlet hoses
Brake booster vacuum hose
Power steering oil hose (to cooler hose)
Power steering oil hose (to gear box pipe)
Power steering oil hose (to reservoir tank)
8) Install canister and bracket.
(1) Install canister bracket on body.
(2) Install canister onto bracket .
(3) Connect canister hoses to pipes .
9) Install cooling system .
(1) Position radiator ASSY into engine compartment .
(2) Install radiator upper bracket.
(3) Connect radiator inlet hose to water pipe .
(4) Connect radiator main fan and sub-fan connector .
(5) Install V-belt cover.
(6) Lift up the vehicle .
(7) Connect radiator outlet hose to thermostat, and
ATF cooler hoses to pipes.
1-1g. 27
10) Tighten nuts, which hold lower side of engine to
transmission, and install lower side of starter.
Tightening torque : N"m (kg-m, ft-lb)
46-54(4.7-5 .5,34-40)
11) Tighten nuts which install front cushion rubber to
sub-frame .
Make sure that the locator is into the elliptical hole in
sub-frame.
t-1g . 1u
Tightening torque : N"m (kg-m, ft-Ib)
54-83(5.5-8.5,40-61)
13