Table of Contents
Advertisement
BRAKES
[w2Fo] 4-4
1 nrle n ;n
C4-538
Fig . 75
8) Install guide pin boots on caliper body .
9) Install lock pin boots on caliper body and insert lock
pin sleeve into place .
c . Replace pads if there is oil or grease on them.
3) Apply thin coat of PBC GREASE (725191330 or
003607000) to the frictional portion between pad and
pad clip .
4) Install pads on support .
Guide pin
Shim
Outer pad
Shim I Rubber coating)
Shim (Stainless)
Shim (Stainless)
u
Shim
(Rubber
I
Pad clip
coating)
Inner pad
Pp ad must be installed
with the clip of pad facing
lower side of vehicle.
84-371
Fig. 76
F: INSTALLATION
5) Install caliper body on support.
1) Install disc rotor on hub.
6) Connect brake hose .
2) Install support on back plate.
7) Bleed air from brake system .
a. Always replace the pads for both the left and right
wheels at the same time. Also replace pad clips if they
are twisted or worn.
b. A wear indicator is provided on the outer disc brake
pad. If the pad wears down to such an extent that the
end of the wear indicator contacts the disc rotor, a
squeaking sound is produced as the wheel rotates. If
this sound is heard, replace the pad .
41
Advertisement
Table of Contents
Troubleshooting
