Road Test Inspection; W: Tie-Down Service Holes; X: Fuel System For Leakage; A: Operation Of Indicator Lights And Gauges - Subaru SVX 1992 Manual

1-4 [oiwo] PRE-DELIVERY INSPECTION
W: TIE-DOWN SERVICE HOLES
CHECK POINTS
Installation of plugs
1 . Install plugs which are stored in console box into
tie-down service holes in rear gusset frame .
2. Road Test Inspection
A: OPERATION OF INDICATOR LIGHTS
AND GAUGES
CHECK POINTS
1 . Operation of indicator lights
2. Operation of gauges
Check the operation according to the "Owner's
manual".
a . Perform this inspection with the selector lever in the
"P" position .
b. Set the parking brake.
c. Do not race the engine excessively .
B: TACHOMETER, RADIO, ETC.
Fig. 23
CHECK POINTS
Operation of tachometer, radio, cigarette lighter,
rx
: FUEL SYSTEM FOR LEAKAGE
I etc.
CHECK POINTS
1 . Installation of fuel hose and pipe . And condition
of clamps
2. Fuel system for leakage
1 . Check the fuel hose's layout, and also search for
interference with other parts, twists, or damage, check
the condition of the clamps .
Check the fuel and air breather pipes visually or by
feeling with your fingers from the underside. Retighten
the clamps if necessary .
a. When retightening the clamps, do not tighten them
excessively.
b. When checking the fuel system, use extreme care to
prevent accidental fires.
2. Without starting the engine, turn the ignition switch
to the ON position, and operate the fuel pump to
pressurize the fuel system . Then check the fuel system
for leakage .
Tachometer
Race the engine two or three times, and check the
tachometer's operation .
Do not race the engine more than necessary.
Radio
Check the operation according to the "Owner's
manual" .
Cigarette lighter
To operate, push in the knob completely and wait for a
moment . The lighter will click out of holder automati-
cally when ready to use .
CAUTION :
a. To avoid the possibility of being burned, do not
hold the cigarette lighter in by hand. This may also
cause damage to the lighter heating element.
b . When replacing the knob, it is recommended that
you use only a genuine part. If you use either non-
genuine parts or any combination of parts different
from original knob-and-socket combination, it may
cause overheating due to a short circuit .
10