Subaru SVX 1992 Manual page 206

ENGINE
[W5D1] 2-3
D: ASSEMBLY
1. CRANKSHAFT AND PISTON
O
T 43 - 46
(4 .4 - 4.7, 32 -:734 ® I /~-
T : N-m
(kg-m, ft-1b)
Side
mark O
C2-300
Fig . 129
1) Install connecting rod bearings on connecting rods
and connecting rod caps .
2) Install connecting rod on crankshaft.
a. Apply oil to the surfaces of the connecting rod
bearings .
b. Position each connecting rod with the side marked
facing forward .
3) Install connecting rod cap with connecting rod nut .
Ensure the arrow on connecting rod cap faces the front
during installation .
a. Each connecting rod has its own mating cap. Make
sure that they are assembled correctly by checking
their matching number.
b. When tightening the connecting rod nuts, apply oil
on the threads.
4) Installation of piston rings and oil ring.
(1) Install oil ring spacer, upper rail and lower rail in
this order by hand. Then install second ring and top
ring with a piston ring expander .
(2) Position the gaps of the piston rings and oil ring
as shown in the figure .
Fig. 131
Identification mark
(RH or CHI
R' Oil ring
Oil ring upper rail
lower rail
30°
25*
Bend over pawl
of upper rail and
attach to hole . 3 ,
30°
Top ring
_' Second ring
oil ring spacer
82-056
Fig. 130
5) Install circlip .
Install new circlips in piston holes located opposite
service holes in cylinder block, when positioning all
pistons in the corresponding cylinders .
67
*