No Rmon Event - Siemens SCALANCE XC-200 Configuration Manual

Diagnostics
12.4 RMON
Parameter
event-description
owner
ownername
trap
notify
Result
The event is configured.
Further notes
You delete an entry with the no rmon event command.
You display the RMON Event Table with the show rmon events command.
You show the details of the SNMP community with the show snmp community command.
12.4.2.6

no rmon event

Description
With this command, you delete an entry from the RMON event table.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no rmon event <number (1-500)>
The parameter has the following meaning:
Parameter
number
582
Description
Description of the event that is output in
the message.
Keyword for the person responsible
Name of the person responsible
Keyword for selecting an SNMP notifi‐
cation
Name of the SNMP notification to be
triggered.
Description
Number of the event entry to be deleted 1 ... 500
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
max. 127 characters
-
max. 127 characters
-
The only valid entry allowed is
"SNMPv1Traps".
You can configure the sending of
traps globally with the command
snmp notify.
Range of values / note
Configuration Manual, 07/2017, C79000-G8976-C361-06