No Spanning-Tree Mst Pseudorootid - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.3 Spanning Tree
Further notes
You can reset the settings to the default values with the no spanning-tree mst
pseudoRootIdcommand.
You display this setting and other information with the commands that start with show
spanning tree ....
6.3.5.17

no spanning-tree mst PseudoRootId

Description
With this command, you reset a pseudoroot MAC address and the priority of the spanning tree
configuration to the default values.
The default values are as follows:
● The priority is configured to the priority of the device.
● The MAC address is configured to the MAC address of the device.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no spanning-tree[mst<instance-id(1-64)>]pseudoRootId
The parameters have the following meaning:
Parameter
mst
instance-id
Result
The pseudoroot MAC address and the priority are rest to the defaults.
Further notes
You configure the settings with the spanning-tree mst pseudoRootId command.
You display this setting and other information with the commands that start with show
spanning tree ....
256
Description
Keyword for a spanning tree instance
Number of the instance
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
1 ... 64
Configuration Manual, 07/2017, C79000-G8976-C361-06