Show Pse Status; Commands In The Global Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

3.5.1.2

show pse status

Description
This command shows the current settings of the PoE power supply of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show pse status [<integer>]
The parameter has the following meaning:
Parameter
integer
If you do not select any parameter, the entries are displayed for all available PSEs.
Result
The current settings of the PoE power supply of the device are displayed.
3.5.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Number of the PSE
Configuration
3.5 PoE
Range of values / note
-
111