No Dot1X Port-Control - Siemens SCALANCE XC-200 Configuration Manual

Security and authentication
11.5 Port Based Network Access Control
Result
The port control parameter is configured.
Further notes
You can reset the port control parameter to the default with the no dot1x port-control
command.
You can display the status of this function and other information with the show
dot1xcommand.
11.5.3.14

no dot1x port-control

Description
With this command, you reset the port control parameter of the authenticator to the default
value.
The default value is force-authorized.
With this, data traffic is permitted without restrictions.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x port-control
Result
The port control parameter of the authenticator is reset to the default value.
Further notes
You configure the port control parameter with the dot1x port-control command.
You can display the status of this function and other information with the show
dot1xcommand.
538
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06